Outside Mount - Levolor Fabric Instalación

INSTALLATION
OUTSIDE MOUNT (OM)
STEP 1: MARKING THE BRACKET LOCATIONS
IMPORTANT: The brackets must be flush against
a flat mounting surface. Do NOT mount brackets
on curved molding.
•
Center the headrail over the window
opening at the desired height.
•
Mark screw locations for each L bracket
approximately 3" from end of cassette,
2 holes per bracket.
— Use a level to ensure all brackets will be in alignment.
•
If more than two installation brackets come with your order, space additional
bracket(s) evenly between the two end brackets, no more than 30" apart.
STEP 2: INSTALLING THE BRACKETS
•
Pre-drill screw holes using a
using pencil marks as a guide.
— If installing brackets into wood,
used supplied screws.
— If installing into drywall, use
anchors in combination with
supplied screws.
•
Screw in L brackets at marked
locations, 2 screws per bracket.
•
Ensure all brackets are square with each other.
•
Attach cassette mounting bracket to L bracket using screws and wingnuts.
— Make sure the release tab is always mounted on the bottom.
STEP 3: INSTALLING THE SHADE
•
Hook the top, middle rib of the cassette
valance onto all of the bracket hooks.
•
Rotate the back of the cassette valance
firmly upwards and toward the window
until the groove at the bracket snaps
into place.
CAUTION: Be sure the bracket and headrail are properly secured
!
before operating the shade. Failure to do so may result in the shade
falling and possible injury.
10
Continuous Cord Loop Lift Control–Cassette Valance
Bracket
Bracket
⁄ " drill bit,
1
16
Drywall
Anchors Drywall
Anchor
Screw
Screw
Bracket
Bracket