Buhnen HB 230E Manual De Instrucciones página 12

2SHUDWLQJ ,QVWUXFWLRQV
3.2.3 Status Messages and Error Indicators
Display
Decimal point Left
flashes
ERR
F1L
F1H
--
EP
3.3 Adjustments on the Unit
The stroke limiter (7) can be used to repeatedly extrude precisely metered amounts of glue.
Set the required amount of glue with the aid of the stroke limiter (7).
The stroke limiter can also be used to adjust the comfort of trigger (4) action.
3.4 Notes on Gluing
The surfaces being glued should be at room temperature and be free of dust, grease, and moisture.
Materials coated with or containing wax, separating oils, plasticizers, or impregnation agents may
cause the bond to come apart immediately or at a later date.
Apply the hot melt adhesive in either dot or bead form. Large dots retain their adhesive strength for
longer than small ones. Firmly press the materials together straight away for several seconds.
Slow, continuous extrusion will ensure that the glue does not fall below application temperature.
3.5 Breaks / End of Work
If no hot melt adhesive is required for more than 20 - 25 minutes, the unit must be switched off using
the ON/OFF key (8) of the temperature regulator (4).
The glue stick can remain in the unit for re-melting when the glue gun is used next time.
Cause
Heating up phase is active
Exceeding the temperature stated
in parameter P31
Sensor error, short circuit
Sensor error, sensor defective
Key disabling active
Data loss in the parameter memory
the heating up phase is over when the
set value has reached just under
2 degrees
Leave it to cool down
Check the sensor
The error indicator also displays after
the error has been eliminated until it is
confirmed with the DOWN key.
Check the sensor
The error indicator also displays after
the error has been eliminated until it is
confirmed with the DOWN key.
see parameter P19
Repair of the Regulator
- 12 -
Action