Connect Power Cords - HP LaserJet 9000 Manual Del Usuario

Ocultar thumbs Ver también para LaserJet 9000:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Step 11 Connect power cords
This section describes how to connect the power cord. HP
recommends connecting the power cord to a surge protector.
1
2
3
4
26
Product Setup
1
Locate the power button on the front
of the product. Make sure the
product is turned off (button out).
CAUTION
Do not connect the product power cord
to the power-cord connector on
Tray 4. That connector is designed to
connect paper output devices such as
the multifunction finisher to Tray 4.
2
Connect the power cords to the
product power cord connector and to
the Tray 4 connector. Then connect
the power cords to an adequate AC
outlet.
Note
For best performance, a dedicated 15 A
outlet is recommended.
3
Connect the high speed copy
connect cable to the copy processor
board. Be sure to run the cable
under the standoff.
4
Press the power button to turn the
product on (button in). After the
product warms up, a prompt will
appear asking you to configure your
control panel display language. (See
Step 12, "Configure the control panel
display language.")
ENWW

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Laserjet 9000l

Tabla de contenido