Commissioning; Danger - JAC Full 520 T2 Manual Del Usuario

This machine complies with Machinery Directives 2006/42, 2006/95, 2004/108 and is CE marked as
proof of this.
Please familiarise yourself with the safety pictograms displayed on the machine:
This pictogram indicates a cut hazard. You will find it at the front and at the rear of
the machine around the loaf positioning and recovery areas (fig.10, n°31).
This pictogram indicates an electrocution hazard. Please isolate the machine
before carrying out any work on it. You will find it at the back of the machine close
to the power cable and inside the machine on the electrical enclosure (fig.10,
n°32).
You will find the circuit diagram for the machine on the electrical enclosure door (fig.10, n°33).
5.4

Commissioning:

Before commissioning, ensure that there are no extraneous objects interfering with the machine's
moving parts.
For machine operation, please refer to the "Operation" chapter.
5.5

Danger:

If the user or the machine is in danger, you must use the main isolator switch to cut the power supply
to the machine (fig.4, n°23,25).
Remove the plug from the power socket before any maintenance and/or servicing work.
Do not touch the blades, even if they are stationary.
To replace the blades, have the work done by your approved dealer.
Always wear cut-resistant gloves when replacing the blades or when working in the vicinity of the
blades.
Any maintenance work or replacement of parts must be carried out by a qualified individual.
English
10