3-Way Call; Register A New Handset To Your Base - Steren TEL-620 Manual De Instrucciones

7.2 3-Way call

You can hold a three-way conversation between an external caller and another handset
user.
1. During an external call, press INT. Your caller is put on hold.
2. Enter the handset number you want to invite.
3. When the handset answers, press to connect all three callers. The icon is
displayed to indicate a 3-way call.
4. If the other handset does not answer, press INT to return to your external caller.
5. Press to end the call.

7.3 Register a new handset to your base

Note: Handset batteries must be fully charged and you must be close to the base to
register.
Handsets that were supplied with your base are already registered.
1. At the base: Press and hold for 3 seconds until you hear two beeps. You now have
90 seconds to register the handset.
2. At the handset: press MENU, scroll ▼ to REGISTER and press MENU.
3. Scroll ▼ to REG BASE and press MENU.
4. Enter the base number (1–4). The numbers flashing are already in use.
5. The display will show SEARCHING...1 When the handset finds the base signal, the
SEARCHING and base identification number is displayed.
6. The display will ask for the PIN to be entered. Enter the PIN (the default setting: 0000)
and press MENU to confirm. You will hear a beep. The handset is now registered.
If the base is not found after a few seconds, the handset returns to standby. Try registering
again.
When a handset is registered to a base, it is automatically assigned a number which is
displayed on the handset and must be used for internal calls.
If registration does not work:
• Try again selecting a diff erent base number.
• Make sure there is no other electrical equipment very close by that may interfere with
the registration signal.
29