Best CPD9M Serie Instrucciones De Instalación página 8

12. REINSTALL THE FILTERS
Remove the protective plastic film covering the filters before installing them.
It is recommended to install side filters first and to finish with center one(s).
1. Insert the end with the spring of the baffle filter
into the front channel of the power pack.
2. Raise the other end toward the inside of power
pack and insert in the grease drip rail of the
power pack.
13. OPERATION
BLOWER
The blower is operated using two controls.
Use the on/off rocker switch (1) to start and stop the blower. When turned ON, the
switch turns red and the blower operates at the speed set by the speed control
knob (2).
Turn the speed control knob counterclockwise to increase blower speed –
clockwise to decrease speed.
COOKTOP LIGHTING (HALOGEN)
Use the on/off rocker switch (3) to turn the halogen lights ON or OFF.
HEAT SENTRY™
This power pack is equipped with a Heat Sentry™ thermostat. This thermostat is a device that will turn on the blower to high speed if it
senses excessive heat above the cooking surface.
1) If blower is OFF - it turns blower ON to high speed.
2) If blower is already ON - it sets blower on high speed.
The HEAT SENTRY can start the blower during a range top fire or other excessive heat situations even if the power
pack is turned off. In this case, it is impossible to turn the blower OFF using control panel switch. To stop the
blower, do it from the main electrical panel.
When the temperature drops to normal, the blower will return to its original setting.
CAUTION
1
HD0526
WARNING
!
8
2
1 2 3
HC0087
1) ON/OFF blower switch
2) Blower speed control knob
3) Halogen light switch