Publicidad
Step 9
Carefully turn your unit over onto its front edges and
å
tighten the eight HIDDEN CAMS in the BACKS (XX).
Then, lay the SMALL BACK (D2) over your unit.
å
Make equal margins along the top and both side edges of
å
the SMALL BACK (D2). Push on opposite corners of your
unit if needed to make it "square".
Fasten the bottom edge of the SMALL BACK (D2) to the
å
BACK (XX). Use six BLACK 9/16" LARGE HEAD SCREWS (RR).
Fasten the top and both side edges of your SMALL BACK to
your unit using the NAILS (UU).
Tighten eight HIDDEN
CAMS in the BACKS (XX)
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
Page 14
XX
Start
Arrow
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Cut-out are
BLACK 9/16" LARGE HEAD SCREW
used for lifting
XX
Tighten
Maximum
210 degrees
Minimum
190 degrees
401291
RR
(6 used in this step)
Cut-out are
used for lifting
D2
NAIL
(12 used in this step)
Arrow
www.sauder.com/services
UU
Publicidad
