Publicidad
Step 10
1
D22
Groove
Insert the LARGE DRAWER SIDES (D22 and D23)
å
at an angle into the slot at each end of the LARGE
DRAWER FRONT (G2).
3
M64
Surface with
HIDDEN CAM
Fasten the DRAWER BRACE (M64) to the LARGE
å
DRAWER FRONT (G2). Tighten one HIDDEN CAM.
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
G2
D23
Maximum
Arrow
210 degrees
Minimum
190 degrees
G2
VIEW THE T-LOCK BOX VIDEO
2
With the palm of your hand, tap the
DRAWER BOTTOM down into the groove.
U n
fi n
s u
i s h
r f a
e d
c e
D22
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D981) into the grooves in
å
the LARGE DRAWER SIDES (D22 and D23) and LARGE
DRAWER FRONT (G2).
4
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D22
M64
Fasten the LARGE DRAWER BACK (D175) to the LARGE
å
DRAWER SIDES (D22 and D23) and DRAWER BRACE (M64).
Use five BLACK 1-9/16" FLAT HEAD SCREWS. (30S). Repeat
this step for the other large drawers.
401291
D981
G2
D23
30S
(15 used in this step)
D175
Be sure the
DRAWER
BOTTOM
D23
inserts into
the DRAWER
BACK groove.
Page 15
Publicidad
