Preselecting The Speed - Flex RE 14-5 115 Instrucciones De Funcionamiento Originales

RE 14-5 115
Operation with guide table
t^okfkd>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=ÉäÉÅíêáÅ=
éçïÉê=íççäI=éìää=çìí=íÜÉ=ã~áåë=éäìÖK
Attaching the guide table
 Loosen and unscrew the locking screw (1.).
 Push guide table over the pins on the
housing (2.).
 Screw in locking screw (3.).
 Remove guide table in reverse sequence.
Attaching milling head
 Press and hold down the spindle lock (1.).
 Screw milling head onto the spindle (2.)
 Tighten milling head clockwise using the
holding wrench (3.).
 Remove milling head in reverse sequence.
Setting the milling depth
The milling depth can be set from 0 to 6 mm
in 6 stages.
 Loosen locking screw anti-clockwise (1.).
 Adjust the guard by turning it to the required
height (2.).
 Tighten locking screw (3.).

Preselecting the speed

 To set the operating speed, move the dial
to the required value.
Switching the electric power tool
on and off
Brief operation without engaged switch
rocker:
 Push the switch rocker forwards and hold
in position.
 To switch off the power tool, release the
switch rocker.
23