Warning Indicators; Starting The Program; Child-Proof Lock - Saivod STE 7 Manual Del Usuario

Auxiliary function
Cancel Audio Warning
Your machine will send out an audio warning
when the program comes to an end. If you
do not want to hear this buzzing, you need to
press the "Cancel Audio Warning" button. The
relevant LED will light up when this button is
pressed and an audio warning will not be given
when the program comes to an end.

Warning indicators

C
Warning indicators may differ according to
the model of your machine.
Filter cleaning
A warning LED will light up to remind filter
cleaning after the program finishes.
C
If the filter cleaning warning LED lights
up continuously, please refer to, "Solution
suggestions for problems".

Starting the Program

Press "Start/Pause/Cancel" button to start the
program. "Start/Pause/Cancel" button will
light up to indicate that the program has
started.
Progress of program
Progress of a running program is shown through
the program follow-up indicator.
At the beginning of every program step, the
relevant indicator LED will light up and light of
the completed step will turn off.
"Drying":
- Drying level will be illuminated during the whole
drying process until the drying degree reaches
"iron dry".
"Iron Dry":
- Starts to illuminate when the drying degree
reaches "iron dry" step and remains
illuminated until the next step.
"Ready to wear":
Starts to illuminate when the drying degree
reaches "Ready to wear" step and remains
illuminated until the next step.
Illuminates when the program comes to an end
and anti-creasing function is activated.
"Final / Anti-creasing":
- Illuminates when the program comes to an end
and anti-creasing function is activated.
C
If more than one LED light up or flash
concurrently, it means there is malfunctioning
or a failure (please see, Solution suggestions
for problems).
Changing the program after the
program has started
You can use this feature after your machine has
started to dry your clothes under higher or lower
temperatures.
For example;
Press and hold the "Start/Pause/Cancel" button
for about 3 seconds to "Cancel" the program in
order to select "Extra Dry" program instead of
"Iron Dry" program.
Select the "Extra Dry" program by rotating the
program knob.
Press "Start/Pause/Cancel" button to start the
program.
C
The program which is selected first will go on
even if the program selection button is moved
and another program mode is selected while
the machine is operating. You must cancel
the ongoing program in order to change the
drying program. (See. Ending the program
through canceling)
Adding/removing laundry in standby
mode
If you want to add or remove laundry into/from
your machine after the drying program has
started, put the machine into "Pause" mode
by pressing the "Start/Pause/Cancel" button.
Drying process will stop. Open the door at
Pause position and close it again after adding or
taking out laundry. Press "Start/Pause/Cancel"
button to start the program.
C
Any laundry added after the drying process
was started may cause the already dried
clothes in the machine intermingle with wet
clothes and the result will be wet laundry after
the drying process is over.
C
It is recommended to add laundry before the
program is started since it will increase the
program time and energy consumption.

Child-proof lock

There is a childproof lock to prevent any
program interruption due to the pressing of
keys while the program is on. The loading
door and all keys except the "On/Off" key
on the panel are deactivated when the child-
proof lock is active.
after the program is over or to interrupt
the program, the childproof lock should be
deactivated. To deactivate the child-proof
lock, press the same buttons again for 3 sec.
C
2 beeps when activating and 1 beep when
deactivating the child-proof lock is heard.
11 - EN
In order to activate the
childproof lock, press
on the "Start/Pause/
Cancel" and "Cancel
audio warning" buttons
simultaneously for 3
seconds.
To start a new program