Maintenance And Cleaning; Fluff Filter; Water Tank - Saivod STE 7 Manual Del Usuario

5

Maintenance and cleaning

Fluff filter

Lint and fibres released from the laundry to the
air during the drying cycle are collected in the
"Fluff Filter".
C
Such fibre and lint are generally formed
during wearing and washing.
A
Always clean the filter after each Drying
process.
C
You can clean the filter and filter area by
vacuum cleaner.
For Filter cleaning;
1. Open the cover
2. Remove the fluff filter by pulling it up and
open the filter.
3. Clean lint, fibre, and the fluff by hand or with a
soft piece of cloth.
4. Close the filter and place it back into its seat.
Sensor (models equipped with a
sensor)
There are humidity sensors
in your machine that detect
whether the laundry is dry or not.
For sensor cleaning; Open the
door of the machine. Allow the
machine to cool off if drying
has been carried out. Wipe the
metal sensors with a soft cloth, dampened with
vinegar and dry them.
C
Clean metal sensors 4 times a year.
A
Never use solvents, cleaning agents or
substances alike when cleaning as these might
cause fire and explosion!

Water tank

The moisture in the damp laundry is taken from
the laundry and condensed. Drain the water
tank after each drying cycle or during drying
when "Water tank" warning LED comes on.
A
Condensed water is not drinkable!
A
Never take out the water tank when the
program is running!
Water tank may be located in two different
places, namely, inside the drawer on the panel
or inside the kick plate cover.
If you forget to drain the water tank, your
machine will stop during the following drying
cycles when the water tank is full and the "Water
tank" warning LED will light on. If this is the
case, press the "Start/Pause/Cancel" button to
resume the drying cycle after draining the water
tank.
To drain the water tank; Carefully remove the
water tank by opening the kick plate cover/
pulling the drawer.
1. Drain the water by opening the water tank
cover.
2. If there is lint accumulation in the water tank
cover, clean it and press to close.
3. Place the water tank into its seat.
Condenser
Hot and humid air in the condenser is cooled with
the cold air from the room. Thus, the humid air
circulating in your machine is condensed and then
pumped into the tank.
C
Clean the condenser after every 20 drying
cycles or once a month.
To clean the condenser; If a drying process
has been carried out, open the door of the
machine and wait until it cools down. Unlock
the 4 condenser locks after opening the kick
plate. Pull out the condenser. Clean the
condenser with pressurized water and wait until
the water drains.Replace the condenser with the
side labeled "Top" facing upwards. Lock the 4
condenser locks. Make sure that the red lock
on the upper right corner is engaged securely.
Close the kick plate cover.
Close properly and
check the locking
latchs?
13 - EN