Kohler STERLING 6105 Serie Guia De Instalacion página 11

Attachment Clip
3/4" (1.9 cm) Plywood
16-1/2"
(41.9 cm)
13/16" (2.1 cm)
7. Secure the Bath to the Deck/Alcove
For Drop-In/Island Installations
Make sure that there is a drop cloth or other protective liner in the bath.
The bath can be attached using the attachment clips (provided) or large-head roofing nails.
Verify that the studs are within 1/8" (3 mm) of the bath at the recommended clip or nail locations.
Shim if necessary.
To secure with attachment clips:
Refer to the diagram in the "Roughing-In" section for the recommended fastener locations.
Position the bottom lip of the attachment clip under the edge of the bath at the side of the stud, as
shown.
Slide the attachment clip into place between the center of the stud and the bath.
Bend the tab of the attachment clip over the bath flange with a pliers.
NOTE: Install either large-head roofing nails or flat head screws to secure the attachment clips to the
studs. If hammering a nail, use caution in order to avoid hitting the bath.
Install the attachment clip with a flathead screw or nail.
To secure with roofing nails:
CAUTION: Risk of property and product damage. Install the nail or screw above the bath flange. Do
not nail or drill through the bath flange, as this could crack the flange and cause leaks.
Refer to the diagram in the "Roughing-In" section for the recommended fastener locations.
Install the flathead roofing nails or other large-head fasteners at all of the fastener locations
indicated. Install more if desired.
Sterling
Bath Flange
2-1/2" D. Overflow
13"
(33 cm)
2" D.
Drain
5-1/2" (14 cm)
Section at Drain End
Bath Flange
Screw
13-7/8"
(35.2 cm)
11
Roofing Nail
Attachment Clip
1019810-2-C