Kohler STERLING 6105 Serie Guia De Instalacion página 3

F
8"
G
(20.3 cm)
C
4" (10.2 cm)
Roughing-In
A
61050100 60"
(152.4 cm)
IMPORTANT! Dimensions given in the roughing-in information are critical for proper installation.
Construct the framing and plumbing accurately.
IMPORTANT! All dimensions are nominal. The stud opening tolerance is plus 1/8" (3 mm) and minus 0.
NOTE: If a firewall is required, increase roughing-in dimensions by its material thickness. Measure stud
opening dimensions toward the exposed side of the wall material.
NOTE: If installing this bath to a masonry wall, provide for plumbing connections. Construct a separate
frame wall at least 6" (15.2 cm) from the masonry wall.
Position the bath for drainage clearance through the floor joists or slab, and for convenient plumbing
installation.
Position studs as shown for installing attachment clips and plumbing fixtures.
The bath with apron can be installed in an alcove directly to the framing studs, and wallboard or other
water-resistant material. When installing over wallboard or other water-resistant wall material, increase the
framing dimensions to accommodate the material thickness. The bath without apron can be installed in a
cutout in the floor (drop-in) or in a built-up area (island).
For baths with wall surrounds, do not install accessories that require backing or support. Such installation
could void the warranty.
Install an access panel at the drain end of the bath. The access panel is not shown.
Sterling
30" (76.2 cm) 30" (76.2 cm)
14" 14"
(35.6 cm) (35.6 cm)
B
D
Drain Cutout
2" (5.1 cm) D. Drain
Backing Block
A
Recommended Support Clip or
Roofing Nail Location (5 Total)
B C
10" 43-1/2"
(25.4 cm) (110.5 cm)
D
H
Block Locations (3)
When Optional
Apron is Used
Diagrams shown are representative and for use with the table only.
Your fixture may appear different from the illustrations.
D E
21" 18-1/8"
(53.3 cm) (46 cm)
3
A
B
F G
13" 29"
(33 cm) (73.7 cm)
C
E
H
41-3/16"
(104.6 cm)
1019810-2-C