Dash Disassembly; Kit Preparation - Metra 95-3004 Instrucciones De Instalación

DASH DISASSEMBLY

1. With the key in the on position, apply
the parking brake, place the shifter
into low gear, and then tilt the steering
wheel down as far as it will go.
2. Unclip the factory dash panel, unplug all
switches, and then remove the panel.
(Figure A)
Note: Take precaution pulling the panel
over the factory hazard button.
Continue to Kit Preparation
2
(Figure A)

KIT PREPARATION

1. Snap the cutting template onto the
dash panel and mark the inside area to
be cut with a pencil. (Figure A)
2. Remove and discard the cutting
template, then cut the areas marked out
in the previous step.
3. Cut and remove the radio rear support
from the dash cavity.
Continue to Kit Assembly
Remove shaded area
(Figure A)
|
1.800.221.0932 MetraOnline.com