Steren COM-822 Manual Del Usuario página 31

To add or modify a MAC Address Filtering entry, follow these
instructions:
1. Enter the appropriate MAC Address into the MAC Address field.
The format of the MAC Address is XX-XX-XX-XX-XX-XX (X is any
hexadecimal digit). For example: 00-0A-EB-B0-00-0B.
2. Enter a simple description of the wireless station in the Description
field. For example: Wireless station A.
3. Status - Select Enabled or Disabled for this entry on the Status
pull-down list.
4. Click the Save button to save this entry.
To modify or delete an existing entry:
1. Click the Modify in the entry you want to modify. If you want to
delete the entry, click the Delete.
2. Modify the information.
3. Click the Save button.
Click the Enable All button to make all entries enabled
Click the Disabled All button to make all entries disabled.
Click the Delete All button to delete all entries
Click the Next button to go to the next page and click the Previous
button to return to the previous page.
For example: If you desire that the wireless station A with MAC
address 00-0A-EB-00- 07-BE and the wireless station B with MAC
address 00-0A-EB- 00-07-5F are able to access the router, but all
the other wireless stations cannot access the router, you can
configure the Wireless MAC Address
Filtering list by following these steps:
1. Click the Enable button to enable this function.
2. Select the radio button: Deny the stations not specified by any
enabled entries in the list to access for Filtering Rules.
3. Delete all or disable all entries if there are any entries already.
4. Click the Add New... button and enter the MAC address
00-0A-EB-00-07-BE/00-0A-EB-00-07-5F in the MAC Address field,
then enter wireless station A/B in the Description field, while select
Enabled in the Status pull-down list. Finally, click the Save and the
Back button.
ENGLISH-31