Steren COM-822 Manual Del Usuario página 9

2.- Power off the router and PC(s). Then turn on the router, and
restart the PC(s). The built-in DHCP server will assign IP
addresses for the PC(s).
In both cases can run the Ping command at the DOS prompt to verify
the network connection between the PC and the router.
Open a command prompt, and type ping 192.168.1.1, and then
press Enter.
If the result displayed is similar to that shown in the next figure, the
connection between your PC and the router has been established.
If the result displayed is similar to that shown in figure, it
means that your PC has not connected to the router. Please
check it following these steps:
1. Is the connection between your PC and the router correct?
The Link/Act LEDs of LAN port on the router and LEDs on your PC's
adapter should be lit.
2. Is the TCP/IP confi guration for your PC correct?
If the router's IP address is 192.168.1.1, your PC's IP address must
be within the range of 192.168.1.2 ~ 192.168.1.254, the gateway
must be 192.168.1.1
ENGLISH-09