Steren COM-822 Manual Del Usuario página 47

Status – Select Enabled or Disabled for this entry on the Status
pull-down list. Enabled means the rule is effective, Disabled means
the rule is ineffective.
Antes de utilizar su nuevo Kit C
Before adding an IP Address Filtering entry, you should enable
the Firewall and the IP Address Filtering function first (shown in
Figure
For example: if you want to block the PCs on your LAN from
accessing websites www.xxyy.com.cn, www.aabbcc.com and
websites with end of .net on the Internet, while no limit for other
websites, you can configure as follows.
1. Click Add New.../Modify shown in Figure
2. Enter the "Effective time" and "Domain Name" in the screen shown
in Figure 4-35.
3. Select the "Status" for the rule as shown in the screen.
4. Finally, click Save to make the rule take effect.
To add additional entries, repeat steps 1-4.
After you finish the configurations, you will see the rules in the table
below:
Click the Delete button to delete the entry.
Click the Enable All button to enable all the entries.
Click the Disable All button to disable all the entries.
Click the Delete All button to delete all the entries.
Click the Previous button to view the information in the previous
ENGLISH-47