Cooper Lighting FW Serie Instrucciones página 3

FW42PC_PCW 825-0142.qxd:FW Series 325-1094 Spreads.qxd
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Always use same wattage and type of bulb that was included with the fixture.
Failure to do so will void the warranty.
Installing your fixture
Step 1: Turn power off at main breaker that runs to the box where fixture will
be installed.
Step 2: Attach adjustable mounting bracket (D) to junction box on wall using
two of the mounting plate screws provided. Either the #6 or #8 screws
provided will fit most standard junction boxes. Position the bracket
so that the mounting studs for the fixture are horizontal. Tighten the
rotation screw on the bracket.
Step 3: Loosen lens screw (E) in the bottom of the fixture completely out and
remove the lens and bulb.
Step 4: Wire the fixture as described in "Wiring your fixture".
Step 5: Position the fixture so that the bracket screws pass through the back-
plate of the fixture housing (A). Tighten the housing to the mounting
bracket with the knobs provided. Make sure your fixture is straight.
Mounting bracket does swivel so you can adjust to get fixture straight.
Step 6: Install the bulb (C) as described in "Installing the bulb" and put
lens (B) back onto fixture housing (A). Insert lens screw (E) and
tighten to secure the lens. Be sure the lens edges and lens screw tab
are fully seated on the inside of the fixture housing (A).
Step 7: Add silicone caulk around fixture to help maintain a weather
resistant seal.
Step 8: Turn power back on. Bulb should glow dimly at first building to full
power in 1-2 minutes.
Note: During daytime installation, the bulb should turn off after 45 seconds
to one minute. This is normal operation. The bulb will restart at night and
operate until dawn. Should you want to operate the fixture during daylight,
cover the light sensor completely with black electrical tape.
Wiring your fixture
Step 1: Turn the power off at main fuse/breaker box.
Call for customer service and/or missing or damaged parts (800-334-6871)
6/3/08
3
4:34 PM Page 3