Start The Selected Formula - Milnor 30022 Serie Guía Del Operario

Chapter 2. Normal Machine Operation
Figure 13: Batch Data for Remote Formula Operation
Weight—the weight of the batch of goods in the machine. This information is usually used along
with other batch data to calculate customer charges or employee productivity. In machines
equiped with optional flow meters and configured for metered water, the weight value is also
used to determine how much water is required to process the batch. The weight value can be
up to three digits.
Customer Code—the identifying code for the customer. This information can help you
determine how much work each customer is submitting. Ten digits are available for customer
code.
Employee Number—the identifying code for the employee responsible for this batch. The
employee number may be up to five digits long.
Pieces—the number of pieces in the machine. This value sometimes replaces the weight value,
especially when charges are made by the piece rather than by weight. Four digits are available
for the number of pieces.
Lot Number—the identifying code for several related batches or customers. At your discretion,
the value entered here might represent a particular route number common to several accounts.
A lot number can be up to 10 digits long.

Start the Selected Formula

2.1.5.
Be sure you've completed these steps before you go any further in the operating procedure.
1. You've loaded the machine at or near its rated weight capacity.
2. You've selected a formula that's appropriate for the goods in the machine.
3. You've entered any batch data the machine controller requires for metered water or Mildata
reporting.
PELLERIN MILNOR CORPORATION
18