Tristar AC-5560 Manual De Instrucciones página 6

Instruction manual
Water Pump Drainage
Connect the water pump drain hose to the unit before operate. When the
water level of internal water tank reaches a predetermined level, the water
pump will be activated and drain the condensed water outside through
the connected drain hose. The maximum delivery lift is 3.0m. (Under this
condition, the drainage hole at the bottom of unit should be blocked with
the rubber blockage to prevent continuous drainage.)
Note: only some heat pump unit contains the drainage function.
Continuous Drainage
• When you plan to leave this unit unused for a long time, please remove
the rubber blockage from the drainage hole at the bottom of unit, and
connect a drain hose to the lower fixing clip. All the water in the water
tank will drain outside.
• If water pump is damaged, continuous drainage can be used, and
under this condition, the water pump is not activated. The unit can also
work well.
• If water pump is damaged, intermittent drainage can also be used.
Under this condition, when the water full indicator lamp lights up,
please connect a drain hose to the lower fixing clip, then all the water
in the water tank will drain outside. The unit can also work well.
6
Installation
• Don't block the air outlet, and the required distance around should be
at least 30cm.
• Socket wiring should be in accordance with the local electric safety
requirements.
Exhaust Hose Installation