Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of
the original
notice
1.1 / Options
Pressure gauge reading.
Reading on the effort sensor
(more accurate) solution to be favoured
1.2 / Example
Blind rivet nut M10 steel to be set with a 10T riveting machine.
Stroke adjustment on 25 mm.
Adjustment of the riveting machine with manome-
ter to 3 bar which corresponds to 42 kN.
• Press the riveter control and wait for the riveter to wedge.
• Release the trigger and check that the insert is correctly in place.
• If the blind rivet nut does not seem to be crimped enough, increase the riveter's
effort a little more.
• To remove the pull pin from the blind rivet nut, unscrew with the rear knob.
50KN BLIND RIVET ADAPTER FOR 10T RIVETER
Effort reading
Sensor 062115
Adjustment of the riveting machine with sensor to 210 bar which corres-
ponds to 42 kN.
210
ou
EN
Pressure adjustment
Pressure reading
Pressure
adjustment
Publicidad
