Siemens SIMATIC S7-1500 Manual Del Usuario página 17

SIMATIC IPC427E / IPC477E (PRO)
If you are using a SIMATIC Microbox PC supported by the CPU, note the following reference information for your device:
Hardware version
BIOS version
Graphics driver
LED use
NVRAM use
Using onboard interfaces for PROFINET or PROFIBUS:
PN / IE (LAN) X1
PN / IE (LAN) X2
PN / IE (LAN) X3
The following hardware configurations of the SIMATIC Microbox PCs are not supported by the CPU:
● Operating system installation on CFast (internal or external) < 16 GB
CPU Power Level
Set the CPU Power Level to "Determinism optimized".
Special features
Unified Extensible Firmware Interface (UEFI)
The IPCs with the Windows 7 Ultimate operating system are delivered pre-installed. Pre-installation takes place in
UEFI mode. Because the CPU1507S does not support UEFI mode, you must install Windows in Legacy mode (MBR data
storage medium).
You can find information on using Legacy mode in the Product Support
(https://support.industry.siemens.com/cs/ww/en/view/109749497).
Windows reboot
To use the Windows reboot on the SIMATIC IPC427E / IPC477E, assign the Ethernet interfaces X2 or X3 to the PC station
in STEP 7.
Instruction "SHUT_DOWN: Shut down target system"
To reboot Windows via Remote Desktop on the SIMATIC IPC477E, also use the "-f" parameter with the Shutdown
instruction for immediate shutdown.
Add-ons to CPU 1505SP (F/T/TF), CPU 1507S (F) Version 2.5
A5E44368019-AA, 04/2018
Property
IPC427E: FS ≥ AA
IPC477E: FS ≥ AA
V21.01.07
Version for Windows 7:
32-bit: 15.45.21.4821
•
64-bit: 15.45.21.64.4821
•
Version for Windows 10:
15.46.05.64.4771
•
Available on supplied USB flash drive with
version 04/2018.
IPC427E: Supported, configurable
IPC477E (PRO): Not supported
Supported, 135 KB can be used for user data
Not supported
Yes
Yes
Notes
The hardware version can be found on the
rating plate of your SIMATIC IPC.
If you did not receive a USB flash drive with the
SIMATIC IPC, contact Customer Support.
17