Siemens SIMATIC S7-1500 Manual Del Usuario página 19

SIMATIC IPC647D / IPC847D
If you are using a SIMATIC Rack PC supported by the CPU, note the following reference information for your device:
Hardware version
BIOS version
Graphics driver
LED use
Using onboard interfaces for PROFINET or PROFIBUS:
PN / IE (LAN) X1
PN / IE (LAN) X2
PROFINET (LAN) X3
(CP 1616 onboard)
MPI / DP X4
(CP 5622 onboard)
BIOS setting
A Windows restart is not supported in the following cases:
● When you use remote management, e.g. iAMT, for your IPC.
● When a hardware RAID is configured in the system after a blue screen.
● When you have configured a hardware RAID with firmware version 7.10-0 (33072) and the release version MR2016.2.
This firmware version is used on devices as of production version "AP".
To restart Windows, reboot the entire PC system.
Use the instruction "SHUT_DOWN": Shut down target system" to reset a crashed Windows session only in the case of a
blue screen.
The following hardware configurations of the SIMATIC Rack PC are not supported by the CPU:
● RAM < 4 GB.
● Enabled onboard RAID.
Special features of the operating system
If you want to use Windows 10 on your IPC847D, use a configuration with LTSB 2016.
Operation using configuration with RAID
The partition with the operating system and the Software Controller must be on the hard disk that is connected via an
AHCI controller.
The following RAID configuration is supported:
● RAID1, 1 TB (2x 1 TB HDD SAS, data mirroring) in removable frame, hot-swap, frontside-mounted; PCIe x8 RAID
Controller incl. ZMCP module (2 slots occupied) + 240 GB SSD SATA (for OS) in removable frame, frontside-mounted.
With a RAID operation, set up the CPU volume on the SSD during setup. You have two options for doing this prior to the
installation:
● Make sure that you have at least 450 MB unpartitioned memory space, for example, by reducing the size of the drive C:\.
● Generate a partition D:\ with at least 1 GB on the SSD.
Add-ons to CPU 1505SP (F/T/TF), CPU 1507S (F) Version 2.5
A5E44368019-AA, 04/2018
Property
SIMATIC IPC 647D: FS ≥ AE
SIMATIC IPC 847D: FS ≥ AE
V19.01.11
Version for Windows 7:
32-bit: 15.36.18.4156
•
64-bit: 15.36.18.64.4156
•
Version for Windows 10:
15.40.36.64.4703
•
Available on supplied Documentation and
Drivers DVD 09/2017.
Not supported
Not supported
Yes
Not supported
Yes, as of FW V1.03.08.046.
Wake up on LAN (X2 P1)
Notes
The hardware version can be found on the
rating plate of your SIMATIC IPC.
Only the graphics driver on the Documentation
and Drivers DVD ≥ 06/2015 supports the
"Windows Reboot" functionality.
If you did not receive the Documentation and
Drivers DVD with the SIMATIC IPC, contact
Customer Support.
For availability of the FW see SIMATIC Product
Information
(https://support.industry.siemens.com/cs/ww/en/
view/92275417)
19