Revell Control X-Razor 24048 Manual De Instrucciones página 7

1. GETTING STARTED:
The thrust controller (the left control on the
remote control) must be facing down after
switching on. Following this, set the remote
control ON/OFF switch to "ON" (pic. 1). The
"POWER ON" LED starts lighting. Set the desired
band using the band selector (pic. 2).
2. TRIMMING THE CONTROLLER:
Taking time to adjust the trimming will ensure that the helicopter flies smoothly. It is easy to do, but does require a little patience and a light touch.
Please follow these instructions carefully: Slowly move the throttle stick up to raise the helicopter to a height of about 0.5 metres to 1 metre.
When the heli-
copter rotates
quickly or slowly
by itself around
its own axis to
the right ...
Turn the yaw trim forward when the helicopter rotates quickly or slowly by itself around
its own axis to the right.
3. FLIGHT CONTROL:
To take off or to make the helicopter fly higher, carefully push the throttle
stick upward.
To move forwards, carefully push the direction stick up.
To make left turns, carefully push the direction stick to the left, provided
that the tail of the helicopter is pointing towards the pilot.
For flying sideways to the left, carefully press the left sideways-flight key in
case the helicopter shows its tail to the pilot.
Flying the Helicopter
Pic. 1 Pic. 2
When the heli-
copter rotates
quickly or slowly
by itself around
its own axis to
the left ...
Turn the yaw trim backward when the helicopter rotates quickly or slowly by itself around
its own axis to the left.
Now set the
ON/OFF switch on
the helicopter's
underside to "ON".
To land or to make the helicopter fly lower, simply lower the throttle stick.
The throttle stick only needs to be moved very slightly to ensure smooth flying.
To move backwards, carefully pull the direction stick down.
To make right turns, slowly push the direction stick to the right, provided
that the tail of the helicopter is pointing towards the pilot.
For flying sideways to the right, carefully press the right sideways-flight key in
case the helicopter shows its tail to the pilot.
Place the helicopter
on the ground with
its tail pointing
towards you. It will
take the gyros
some seconds to
initialize. The
helicopter is
flight-ready as soon
as the colored LEDs
light on the
helicopter's side.
7