Defiant DFI-0553-WH Guía De Uso Y Cuidado página 11

Operation (continued)
3
Testing the light
NOTE: It is recommended that the light be tested before
being placed in regular operation.
Remember to set the switch from Test to Motion after
testing the light.
NOTE: Testing the unit indoors or lower than 7 ft. from
the ground may not enable the light to work optimally
when mounted into its final outdoor position.
NOTE: With the Power button (D) in the OFF position,
allow the unit to charge in direct sunlight for at least 6
hours before testing, or placing into normal operation.
Before placing the light in normal operation (Motion
mode), it is best to test the light LEDs and motion
sensor. Here is the process or doing so:
□
Activate the light by pressing the Power button
(D) to the ON position.
□
Switch the Motion/Test switch to 'Test'. The
light will turn ON, and stay on continuously for
1 minute. Use this time to adjust the LED light
heads to where you would like them to shine
when motion is detected.
□
After the first minute, the light will turn OFF, but
will activate for 5 seconds every time motion
is detected. Use this time to adjust the motion
sensor (C) to where you want the light to detect
motion and activate. While the switch is in 'Test'
mode, the light will continue to activate in 5
second intervals.
□
When finished with these adjustments, switch
back to 'Motion', and the light will go into normal
operation. Depending on your LUX setting and
time of day, the light may turn OFF until it's dark
enough to activate.
11
Please contact 1-866-308-3976 for further assistance.
B
D
C
HOMEDEPOT.com