Defiant DFI-0553-WH Guía De Uso Y Cuidado página 9

Installation (continued)
5
Mounting the solar panel
RECOMMENDED: Caulk around the base and on top of
the screw heads after installation
Place the solar base (F) against the mounting surface
and mark the mounting holes.
□
Place the panel (E) into the base (F) and use the
base screw (BB) to secure the panel (E) in place
on the base (F).
□
If mounting to a wooden surface, drill four 3/32
in. holes into the mounting surface. Install the
four mounting screws (CC) through the solar
panel base (F) and into the mounting surface.
□
If mounting to wall board or brick, drill four 7/32
in. holes into the mounting surface. Insert the
wall anchors (DD) and attach the solar panel
base (F) using the four mounting screws (CC).
□
Once the solar panel base (F) has been installed,
position the solor panel (E) above it, adjusting
the direction and angle of the panel to its desired
position to receive optimal sunlight.
6
Adjusting the solar panel
IMPORTANT: The solar panel (E) must receive as much
direct sunlight over the course of the day as possible.
Keep in mind that shadows may block the sunlight from
reaching the solar panel (E) during the day.
□
Rotate the solar panel (E) to the desired angle.
E
CC
DD
7
Connecting the solar panel to
the light fixture
□
Carefully connect the solar panel (E) cable to
the light fixture (B). Screw the caps on the plugs
firmly.
□
Wrap any excess solar panel cable around the
base (F) located on the rear of the solar panel
(E). Leave enough loose cable to form a drip
loop.
IMPORTANT: Push the switch to the OFF position and
allow the battery to charge with 1 to 2 days of full sunshine
before testing.
B
9
Please contact 1-866-308-3976 for further assistance.
E
F
BB
F
F
HOMEDEPOT.com
E