Other Functions; Setting The Clock; Turning The Clock Display On Or Off; Introduction Of Xm Operation - Pioneer SUPER TUNER KEH-P2030 Manual De Operación

Other Functions

Setting the clock

Use these instructions to set the clock.
1 Press SOURCE and hold until the unit
turns off.
2 Press and hold AUDIO until clock ap-
pears in the display.
3 Press c or d to select the segment of
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
4 Press VOLUME up/+ or down/ to set
the clock.
Pressing VOLUME up/+ will increase the se-
lected hour or minute. Pressing VOLUME
down/ will decrease the selected hour or min-
ute.
# To cancel clock settings, press BAND.
# You can also cancel clock settings by holding
down AUDIO until the unit turns off.
Turning the clock display
on or off
You can turn the clock display on or off.
% Press and hold CLOCK to turn the clock
display on or off.
Each press and hold of CLOCK turns the clock
display on or off.
# The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.
HHHHHHHHHHHHHH

Introduction of XM operation

You can use this unit with a separately sold uni-
versal XM satellite digital tuner system (GEX-
FM913XM) or XM satellite digital tuner (GEX-
P910XM).
For details concerning operation, refer to the
XM tuners operation manuals. This section
provides information on XM operations with
this unit which differs from that described in
the XM tuners operation manual.
! This unit controls XM tuner as an external
unit.

XM operation

XM operation of the following function with
this unit differs.

! Swiching the XM channel select setting

(Refer to this page.)
Swiching the XM channel select
setting
You can switch if you select a channel with a
channel number or from a channel category
when you select a channel.
1 Press LOCAL/BSM to select channel se-
lect setting.
2 Each press of LOCAL/BSM changes the
channel select mode in the following
order:
Channel number select modeChannel cate-
gory select mode
Section
08
17
En