Installation; Installing The Mounting Plate - Defiant DFI-7005-WH-G Guía De Uso Y Cuidado

Installation

1
Determining the mounting
location
NOTE: The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground.
NOTE: Ensure the fixture and the solar panel are located
close enough together for the cord to reach.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
2
Setting the sensor for wall or
eave mounting
□
For wall mounting, turn the ring (1) around
the sensor (C) clockwise until the "W" and the
single indicator is aligned with the mark on the
front of the sensor (C).
□
For eave mounting, turn the ring (1) around the
sensor (C) counterclockwise until the "E" and
the double indicator is aligned with the mark
on the front of the sensor (C).
NOTE: There is a detent at each setting to indicate proper
alignment of the sensor.
3

Installing the mounting plate

NOTE: Make sure there is enough vertical space above
the mounting plate to allow the light fixture to be mounted.
□
Place the mounting plate (D) against the
mounting surface and ensure the mounting
plate (D) is level. Mark the hole locations.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the mounting plate (D) and into
the mounting surface.
Wall Mount
A
W
W
Wall Mount
1
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
mounting plate (D) using the two mounting
screws (AA).
AA
6
E
Eave Mount
E
W
Eave Mount
C
D