Installation (continued)
4
Activating the rechargeable
battery
The light fixture (B) has an ON/OFF switch (2) located
on the back of the light (B) to disconnect the battery
during shipping.
□
Press the "I" indicator on the switch (2) to
activate the rechargeable battery.
5
Mounting the light fixture
□
Slide the rear of the light fixture (B) down onto
the mounting plate (D) until it snaps into place.
6
Mounting the solar panel
IMPORTANT: Caulk around the base and on top of the screw heads
after installation.
□
Place the solar panel (F) against the mounting
surface and mark the mounting holes.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (AA)
through the base and into the mounting
surface.
7
Adjusting the solar panel
□
Rotate the solar panel (F) to the desired angle.
IMPORTANT: The solar panel must receive as much direct sunlight
over the course of the day as possible. Keep in mind that shadows
may block the sunlight from reaching the solar panel during the day.
2
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (BB) and attach the
base using the two mounting screws (AA).
F
F
7
Please contact 1-866-308-3976 for further assistance.
B
O
I
B
W
D
UP
AA
HOMEDEPOT.COM