Operation - Defiant DFI-7005-WH-G Guía De Uso Y Cuidado

Installation (continued)
8
Connecting the solar panel to
the light fixture
□
Carefully route the solar panel cable (3) to the
light fixture (B). Remove the rubber plug (4)
from the bottom of the light fixture (B) and
insert the end of the cable (3) into the opening.
IMPORTANT: Turn the control dial on the side of the sensor to the
OFF position and allow the battery to charge with 2 to 5 days of full
sunshine before testing.
NOTE: Wrap any excess solar panel cable around the
cord management system located on the rear of the solar
panel. Leave enough loose cable to form a drip loop (5).

Operation

1
Adjusting the lamp heads
□
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Determining the motion sensor
detection zone
NOTE: The motion sensor is non-adjustable. It has a
sensing angle of 180° and a range of approximately 40 ft.
depending on the surrounding temperature.
NOTE: When the control dial is set to the "TEST" position,
the light will operate during the day or night. The light will
stay on for 5 seconds after all motion is stopped.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
□
Turn the control dial (E) to the TEST position.
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light (B). The light (B) will come on
indicating motion has been detected.
C
4
A
□
Stop, wait for the light (B) to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
B
W
C
8
B
E
3
5
W
F
G
E