Publicidad
Idiomas disponibles
Idiomas disponibles
All work marked with this symbol requires specialist knowledge and technical understanding.
In the interests of your own safety, have these jobs performed by an authorized KTM workshop.
There, your motorcycle will be optimally cared for by specially trained experts using the auxiliary tool required.
Scope of supply
1x TPMS control unit
2x screw M5x10
2x range change metal nut
2x valve 8.5 mm
2x tire pressure sensor
2x nut for tire pressure sensor
Preliminary work on tire pressure sensor
- Remove the front wheel (see owner's manual).
- Remove the rear wheel (see owner's manual).
NOTE
The following steps are the same for the front and rear wheel.
Condition
Tire has been removed.
Assembly of tire pressure sensor
- Remove nut
.
- Remove valve
.
- Lubricate O-ring
slightly (diluted tire mounting paste).
- Position valve
(included) in the hole on the rim.
The valve points towards the wheel trim ring.
- Position tire pressure sensor
valve.
Tire pressure sensor points backward in the direction of travel.
- Tighten nut
to 7 Nm.
Final work on tire pressure sensor
- Mount and balance tires.
- Install the front wheel (see the owner's manual).
- Install rear wheel (see owner's manual).
with nut
(all included) on the
5
Publicidad
