Sauder Carson Forge Serie Manual Del Usuario página 10

Step 5
Turn two BLACK 9/16" FLAT HEAD SCREWS (32S) into
å
the RIGHT END (A) until the shoulders of the SCREWS
rest on the surface of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the END MOLDING (M75) onto the END (A). Line
å
up the groove in the MOLDING over the heads of the
SCREWS in the END.
NOTE: The MOLDING should be even on both edges of
å
the END.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
Page 10
BLACK 9/16" FLAT HEAD SCREW
(2 used in this step)
M75
Shoulder
32S
A