Sauder Carson Forge Serie Manual Del Usuario página 30

Step 23
1
Groove
J
D36
Pull the DRAWER FRONT BRACKETS (9G) apart and slide them
å
into the grooves in the DRAWER SIDES (D36 and D37). You may
need to gently tap them in with a hammer.
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and
å
"LH" for easy identifi cation.
Fasten the DRAWER FRONT (J) to the DRAWER FRONT
å
BRACKETS (9G). Use four BROWN 9/16" LARGE
HEAD SCREWS (40S).
3
Be sure the
DRAWER
BOTTOM
inserts into
the DRAWER
BACK groove.
Fasten the DRAWER BACK (D77) to the DRAWER SIDES (D36 and D37). Use four BLACK 1-9/16" FLAT
å
HEAD SCREWS (30S).
NOTE: Be sure the SMALL DRAWER BOTTOM (D716) inserts into the groove in the DRAWER BACK (D77).
å
Page 30
Push down
9G
D37
BROWN 9/16" LARGE HEAD SCREW
(4 used in this step)
D77
D36
D716
D37
2
40S
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the SMALL DRAWER BOTTOM (D716)
å
into the grooves in the DRAWER SIDES (D36
and D37) and DRAWER FRONT (J).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
U n fi
n i s h
e d
s u r
f a c
e
D716
D36
D37
J
30S
(4 used in this step)