Evaporator Sanitizing; Cleaning The Drip Tray; Cleaning The Condenser; Cleaning Granitore 1 Condenser - horeca Granitore 1 Manual De Empleo

Note: Correctly install the components as shown in the gure.
The non-lubrication of the cap may cause product leakage from
the tap.

7.6. Evaporator sanitizing

evaporator.
Proceed as follows:
1 prepare the sanitizing solution in a container (follow the instructions on the
3 leave to act for the necessary time (see sanitizing instructions).
It is then necessary to rinse out the tank and evaporator to eliminate all sanitiz-
Important: the tank needs to be rinsed out as described on the
package of sanitizer and in compliance with the hygiene stand-
ards in force in the country of machine use.

7.7. Cleaning the drip tray

The drip tray should be emptied and cleaned daily.
Note: all of the drip trays present in the machine should be
cleaned.
it out.
Fig.45
Wash the tray and grid separately with lukewarm water.
Dry all of the components.
Reposition the grid on top of the tray.
Position the drainage hose in the opening provided.
Fit the tray back in place and press down to secure it to the machine.
- 18 _EN -

7.8. Cleaning the condenser

The condenser may be cleaned solely by a specialized techni-
cian, who must organize all of the operational sequences and
use suitable equipment, in strict compliance with the applica-
ble regulations currently in force.
Periodically clean the condenser situated inside the machine.
Warning: Removing safety guards will expose some sharp sur-
faces of the machine.
A dirty condenser will impair machine performance.
To access the condenser remove the safety guards.
It is forbidden to use the machine when even only one panel
(front, rear or side) is not set properly in place. It is prohibited
for the operator to clean the condenser.

7.8.1. Cleaning Granitore 1 condenser

The safety guards must be removed by means of a suitable screwdriver.
Remove the rear guard after taking out the screws securing it to the frame (the
screws are positioned on the left and right sides).
Fig.46
After removing the guard, use a dry brush to remove the dust that has built up
over time with use.
Fig.47
in position.
SL310006542 Ed.02 - 07-2017