Barrette BOM-34107825 Manual Del Usuario página 6

4.
Ensure gate is square. Measure diagonally from top of
left corner rail (A) to bottom of right corner rail (B) and
note the length. Then, measure diagonally from top of
right corner rail (C) to bottom of left corner rail (D). Note
the length. Make sure both measurements are the same
before installing screws into uprights (Fig. 6).
5.
Install two 6" screws (provided) through each upright
insert and into the rail using the molded grooves on the
insert as a guide (Fig. 7).
6.
Install upright caps onto the top of each upright with
remaining vinyl cement (Fig. 8).
7.
Attaching Boerboel
a. Attaching the hinges to the inside of the gate
will allow the gate to open inward. When attaching
them to the outside, the gate will swing outward.
b. Mark and pre-drill
bottom upright. Secure using six 1
with the hinge) to front and side of the upright (Fig. 9).
Repeat for the bottom hinge.
8.
Hold the gate level to the post, pre-drill holes with
bit and secure with six 1
Repeat for the bottom hinge.
NOTE:
Use 2" blocks to align the gate with the fence and help
hold the gate steady (Fig. 11).
6
Hinge To The Upright:
®
⁄ ⁄ ⁄ ⁄ " pilot holes on top and
3 3 3
32 32
⁄ " screws to the post (Fig. 10). ⁄ ⁄ ⁄
1 1 1
2 2
Gate Gate Gate Gate
2" Blocks 2" Blocks
⁄ " screws (provided ⁄ ⁄ ⁄
1 1 1
2 2
⁄ " ⁄ ⁄ ⁄
3 3 3
32 32
Fig. 11
A
D
Screws
Upright
Fig. 6
C
B
Fig. 7
Fig. 8
Fig. 9
Fig. 10