Failure Signalling; Clothes; Not-Authorized Modifications; Ecology And Pollution - Pegasolift TPL 16 Guía Para El Uso Y El Mantenimiento

Take care when the material is concentrating in one part: if there is not possible to
!
obtain a perfect stability of the load, it is adequate to tie up it and to move slowly,
paying maximum attention.
The overload compromises the stability and the efficiency of the device: as it is
!
shown in figure A of page 13 the load will be put as near as possible to the head of the
lifting group in order to distribute more equally the weight on the four wheels.
Announce immediately to the surveyor all possible irregular utilizations, damages and
failures.
Report any occurred incident, even if there are no consequences, because in such a
way the reasons can be found and thus to eliminate them.
In the case of the stop of the truck due to electric or mechanic failures, announce the
responsible persons in order to make the necessary repairs which should be done
only by authorized personal
Avoid to use the truck being dressed with large or fluttering clothes
!
There is prohibited to come nearer to the parts in movement of the truck with long hair
!
not tied.
Avoid using clothes dirty of oil or fuel because these are easily to get burnt.
!
When using the truck or normal maintenance operations are executed, put on the
!
head a rigid cap and safe shoes; it is compulsory to use safety glasses and gloves
during the maintenance of the battery and of the oleodynamic power unit (the
electrolyte and the hydraulic oil could produce permanent damages to the sight and
skin.
There is strictly prohibited to bring not-authorized modifications to the lifter truck devices
and mechanic part without the previous authorization of the only constructing company:
the modifications could compromise the stability and the functionality of the truck and of
its safety protections implying a danger.
Concerning the utilization and the assimilation of the products used for the truck
cleaning and maintenance, there should be respected the laws in force of the respective
country; in the case of truck dismantlement, observe the anti-pollution norms in force in
the country of utilization.
RECAPITULATION: EXECUTE ALWAYS GRADUAL STARTS AND SLOW DOWNS,
MAINTAINING THE LOAD COMPLETELY PUT ON THE FORKS AT A MAXIMUM
HEIGHT OF 30 CM FROM THE SOIL; CONTROL THE STABILITY OF THE LOAD.
THE LIFTING AND LOWERING OPERATIONS SHOULD BE ALWAYS EXECUTED
WITH A STOPPED TRUCK.
PAY ALWAYS MAXIMUM ATTENTION TO YOUR OWN WORK: A SHORT MOMENT
OF INATTENTION COULD PROVOKE SEVERE INJURIES TO YOU AND TO THE
OTHERS, AS WELL AS DAMAGES TO THE TRUCK AND MATERIALS.
GENERAL NORMS OF SAFETY

FAILURE SIGNALLING

.

CLOTHES

NOT-AUTHORIZED MODIFICATION

ECOLOGY AND POLLUTION

37