Pegasolift TPL 16 Guía Para El Uso Y El Mantenimiento página 52

OTHER PERIODICAL CONTROLS :
Every 500 hours check if there are not damages or burns on the spring pushing the
brushes or on the rotor collector.
Each 1000 hours check if the bearings in double scheme with grease at high
temperature have not leakages; check the perfect fastening of the garnish, the good
fastening of electrical contacts and that the isolation against the mass is more than 2
Megohm.
REPLACEMENT OF THE FRONT ROLLERS
4
3
2
1
4
3
MOTOR WHEEL MAINTENANCE
SINGLE FRONT ROLLER VERSION
To replace the front roller is necessary to:
1) Lifting the forks at the maximum height until the
2) Disconnect the battery plug (see page 12
3) Put the truck on safe supports.
4) Extract the elastic pin (4) and remove the
1
5) Replace the damaged roller, insert the distance
DOUBLE FRONT ROLLER VERSION
To replace the front roller is necessary to:
1) Lifting the forks at the maximum height until the
2) Disconnect the battery plug (see page 12
3) Put the truck on safe supports.
4) Release the roller (2) and the rotation pin (4)
5) Replace the damaged roller, insert the rotation
2
roller isn't as indicate.
"Instruments" n° 1).
rotation pin (2) to release the roller (1) and the
distance pieces (3).
pieces (3) and the rotation pin (2) fixing it with
the elastic pin (4)
roller isn't as indicate.
"Instruments" n° 1).
removing the elastic ring (3).
pin (4) fixing it with the elastic ring (3).
52