Normal Working Conditions; Cleaning Operation - Pegasolift TPL 16 Guía Para El Uso Y El Mantenimiento

The lifter truck was tested to operate under the following conditions:
1) On plane surfaces (that means with asperities of about 1 cm), horizontal an dry ones,
able to support the load due to the truck passage with transported loads, (avoiding the
use on moist surfaces or polluted with grease, oil, soap etc which could compromise
the stability of the truck and of braking action).
2) With a translation which could occur with lowered load at normal speed or with risen
load , only at a low speed and for routes relatively short or for manoeuvre for unloading
or piling.
3) The lifting / lowering should occur only with
4) The load should be
- solid or contained in proper containers which could not be distorted and put on
inclined plane or pallets;
- of a load not over the nominal load of the truck (shown on the identification tag part
1);
- centrally situated regarding the inclined plane or the pallet in order to observe the
indications of this booklet and of the identification tag part 1;
- completely introduced on the forks of lifting device.
5) With good conditions of visibility and illumination;
6) With the operator in normal driving position, that means at the back of the tiller and on
the longitudinal axle of the truck.
1- the cleaning operations should not be executed with easy inflammable liquids or with
tools from metals able to ruin the truck body.
2- during the cleaning operations, all the electric parts should be covered in order to
avoid corrosion of contacts and short-circuits.
3- it is prohibited to execute the cleaning with water under pressure or with vapour
4- before use the truck, check if there are not water stains and that all the circuits are
dried up.

NORMAL WORKING CONDITIONS

CLEANING OPERATION

stopped truck .
40