Preliminary Controls; Forward And Reverse Movement Operations; Lifting And Lowering Operations - Pegasolift TPL 16 Guía Para El Uso Y El Mantenimiento

PUTTING IN FUNCTION AND PALLET TRUCK UTILIZATION

PRELIMINARY CONTROLS:

The stacker ready to use must be in the following conditions:
1) Battery charger plug: disconnected.
2) Slow and fast gear switch: fast gear selected.
3) S tart key: activated
4) Tiller bar: in vertical position

FORWARD AND REVERSE MOVEMENT OPERATIONS:

FORWARD
BACKWARD

LIFTING AND LOWERING OPERATIONS

1) Introduce the forks in the lower part of the pallet on which the load is put with
maximum of care and minimum speed; it is recommended for a bigger stability of
the load to introduce completely the forks (see page 10 "Transport of load").
2) Control that the load is equally distributed on the forks and the positions of the
barycenter is within the limits shown by the arrow on the
3) For lifting: keep pushing the button for lifting (reference page 12 "Tiller head" no. 4)
until the desired height is achieved.
4) For lowering: keep pushing the button for descent (reference page 12 "Tiller head"
no. 4) until the desired height is achieved.
ATTENTION!
executed only with the pallet truck completely stopped.
.
1) Check that slow and fast gear
gear selected.
2) Introduce the start key.
3) Push simultaneously with both hands the tiller head and
bring it in a quite horizontal position: in fast gear mode
the positions completely horizontal and vertical forbid
the forward and reverse movement .
4) Operate the butterfly control buttons for movement:
turning in the sense of watch needles the stacker moves
forward, in the contrary sense the pallet truck moves
reverse. Controlling in an adequate manner the turning
there it is easy to control the pallet truck speed.
It is advised to avoid abrupt and repeated starts and
slowing down in order to avoid overheating of the motor
and rapid discharge of the battery.
The load lifting and lowering operations should be
stacker
43
switch has the slow
.