Sauder Edge Water 414844 Instrucciones De Ensamblaje página 14

Step 10
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (H) and lay it over your unit.
Make equal margins along all four edges of the BACK (H). Push
å
on opposite corners of your unit if needed to make it "square".
Fasten the BACK (H) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the
å
UPRIGHTS (C and D) and SHELF (G2).
NOTE: Perforations have been provided for access through the
å
BACK. Carefully cut out the holes needed.
Fasten the FOOT PLATE (T) to the BOTTOM (F2). Use two
å
SILVER 7/8" PAN HEAD SCREWS (22S).
Push a PLASTIC FOOT (23E) into the FOOT PLATE (T).
å
These perforated
holes must be here.
T
23E
SILVER 7/8" PAN HEAD SCREW
(2 used in this step)
Page 14
F2
22S
414844
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPRIGHTS (C
and D) and SHELF (G2).
H
(54 used in this step)
1N
NAIL
www.sauder.com/services