Ice Container; Storage Drawers - Sub-Zero ICBIW-30 Guía De Uso Y Mantenimiento

STORAGE
Freezer Storage
FREEZER BASKETS
To remove, pull forward until basket stops. Pull the two
plastic tabs located behind the bottom two corners of the
basket forward, then lift up and out. Refer to the illustration
below. To reinstall, push drawer slides in. Align the basket
with slides and push back until it stops. Press down on the
front of the basket to engage slides. Refer to the illustration
below.
If door opening is limited to 90°, the top basket must be
removed before removing the middle or lower basket.
Freezer basket removal.

ICE CONTAINER

Column | To remove ice container, pull freezer drawer open
until it stops and lift container out. To reinstall, pull drawer
carrier out and align the bottom of the container with the
carrier. Refer to the illustration below.
Tall and drawer | To remove ice container, pull freezer
drawer open until it stops and lift container out. To reinstall,
place in the drawer with tabs on the bottom of the container
aligned with slots in the drawer. Refer to the illustration
below.
The ice maker must be turned off by touching
the ice storage container is removed. The unit is equipped
with a 3-minute delay after the ice container is removed, to
ensure cubes are not ejected before ice maker can be deac-
tivated or ice container is reinstalled.
Column ice container. Tall and drawer ice container.

Storage Drawers

CRISPER COVER
The crisper cover in the upper storage drawer can be slid
closed or left open.
To remove, pull the upper drawer all the way out, raise the
front edge of the crisper cover and pull it forward out of the
drawer. Refer to the illustration below.
DRAWER DIVIDERS
To remove or adjust a short divider, flex the long divider
slightly, then pull upward. Refer to the illustration below.
when
To remove a long divider, the short dividers must be
removed. Pull divider up until it stops, rotate counterclock-
wise, then pull upward. To reinstall, align grooves with
drawer tabs, rotate clockwise, then slide down.
Crisper cover. Drawer dividers.
DRAWER REMOVAL
To remove, pull open until drawer stops. Raise the drawer
front and pull out drawer. To reinstall, raise the front of
drawer and place onto the slides. Align the back of the
drawer with hooks on the slide, then align the white pegs
at the front of the slide with holes at the front of the drawer.
Refer to the illustration below.
IMPORTANT NOTE: For drawer models, the upper drawer
has a control cable that must be disconnected before
removing the drawer. Refer to the illustration below.
Drawer removal. Control cable (drawers).
subzero.com
|
5