Descargar Imprimir esta página

KTM Power Parts 75012035044 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6
2
1
3
4
Scope of supply:
1x Retaining bracket
2x 8x11x1.6 cable support sleeve
6x DIN7981 3.5x16 oval head self-tapping screw
2x HH M5x16 collar screw
2x HH M5x20 collar screw
2x DIN 9021 A5 washer
2x 8x13x7 bushing
2x M5 WN 22A threaded insert
1x Self-adhesive REED switch
Mounting
Remove the seat and take the tool set out of the storage compartment.
Carefully drill through the two holes in the compartment (1) using a 10
mm bit. Do not drill down too deeply to keep from damaging the under-
lying fender. Deburr the drilled holes with a suitable tool.
Insert the cable support sleeves (2) and threaded inserts (3) in the
mounting bracket (4).
Place the mounting bracket in the compartment as shown in the photo.
Screw on the mounting bracket, using the M5x16 collar screws and A5.3
washers in the rear and the M5x20 collar screws in the front.
75012035001
60012035160
0981350163
0015050163
0015050203
0021050003
62512035070
54803092050
60012035185

Publicidad

loading