Publicidad
Idiomas disponibles
Idiomas disponibles
8
5
1
2
4
3
6
Connect the leads on the REED switch (1) to the vacant connector on the
wiring harness (2).
Clean and degrease the rear frame (3), position the REED switch (4) so
that it lies completely flat and press to stick on.
Clean and degrease the cast-on elevation (5), position and stick on the
REED switch (6) as shown in the photo. The adhesive tape should hold
the switch in place. Optionally, you can attach the Reed switch 3.5x16
oval head self-tapping screws included in the scope of supply. To
attach, drill two holes in the bottom of the seat using a 2.5 mm bit
(use the REED switch as a template). Perform a function test before
you drill the holes. Do not drill down too deeply to keep from damaging
the seat cover.
Functional check
Carefully read through the alarm system operating instructions and
perform a functional check. Also make sure the REED switch works
correctly (activate the alarm system and remove the seat).
Keep the handheld transmitter for the alarm system handy to be able
to turn it off quickly since the siren has a sound level of 114 dBA.
Publicidad
