Haier HDT18PA Manual Del Usuario página 23

All manuals and user guides at all-guides.com
HDT18PA-MANUAL 10/22/01
Installing Your Dishwasher:
Read install instructions carefully before installation.
Caution: If, after completing these steps, you are unsure that unit is properly
installed, contact a qualified installer. To ensure that your appliance is
properly installed it is recommended that it be installed by a certified
installer.
In order for this dishwasher to work, the following are required:
• COLD WATER SUPPLY
• DRAINAGE FOR USED WATER
• ELECTRICITY: 115 VOLT, 60Hz Outlet
• GROUNDING
• HORIZONTAL FLAT SURFACE
Note: For your convenience, the water inlet hose and drain hose are preinstalled
to the dishwasher from the factory. Both hoses are located behind the
dishwasher at the left bottom of the dishwasher.
1. You dishwasher must be placed on horizontal flat surface near by the sink on the
kitchen bench (countertop). Placing the dishwasher as near to a sink as possible
to allow for proper installation of the water inlet and drainage hoses.
2. Connect the other end of water inlet hose to the cold water faucet.
(Quick Connect Sink Adapter is supplied)
3. The other end of the drain hose must be placed properly in the sink or at your
drain outlet in order to let used water drained out from the dishwasher.
4. Plug in the dishwasher to a regular 115 Volt / 60 Hz, 15 Amp. Outlet.
Dishwasher
Kitchen Counter Top
Note: This figure is for illustration purpose only.
Note: Inspect carefully for any water leak around and back of the machine. If any
leak occurs, double check to see if any connections are loose. You may need
to tighten any loose connections.
11:46 AM Page 23
English
Water Inlet Hose
Faucet
Drain Hose
22