GE PV977 Manual Del Propietario Y Instalación página 20

1 MOUNT TEMPLATE
• Align the template with the marks on the ceiling and
tape in place.
– Be sure the template is oriented correctly
with the front of the hood.
• Use a plumb bob to be sure the mounting holes
will provide parallel alignment with the countertop
below.
• Determine wire access hole location.
• Center punch all screw and determined wire hole
locations.
• Drill pilot holes in the 4 screw locations. Use a 3/16"
bit and drill approximately 1-1/2" deep.
• Drill one 1/2" hole for wires.
Cut one 1/2" Dia.
Wire Access Hole
as Needed
8-1/4" To
Centerline of
Pilot Holes
Cut one 1/2" Dia.
Wire Access Hole
as Needed
NOTE: Do not cut the duct opening shown on the
template for this recirculating installation.
2 INSTALL AIR DEFLECTOR INTO
CEILING SUPPORT
• Lay ceiling support on a firm surface, clip side up.
• Position the air deflector onto the ceiling support,
duct opening up and one of the open sides to what
will be the front of the hood assembly. The tabs
on the deflector will be to the outside of the ceiling
support.
• Using 2 screws
provided, secure the
tabs on the deflector to
the ceiling support.
20
Installation Preparation
Drill 3/16" Pilot Holes
Approx. 1-1/2" Deep
4 Places
10-5/16" To
Centerline of
Cut one 1/2" Dia.
Pilot Holes
Wire Access Hole
as Needed
36" HOOD
TEMPLATE
8-1/4" To
Centerline of
Pilot Holes
Cut one 1/2" Dia.
10-5/16" To Wire Access Hole
as Needed
Centerline of
Pilot Holes
FRONT OF HOOD
31-14772
Printed in Mexico 12-08 JR
3 INSTALL CEILING SUPPORT
AND DEFLECTOR ASSEMBLY
• Using the 4 wood screws provided, attach the ceiling
support using the pilot holes drilled in step 1.
Front
Screws
4 INSTALL LOWER HORIZONTAL
SUPPORTS TO HOOD ASSEMBLY
• Install the lower horizontal support to 4 lower vertical
supports with 8 - 4.2x8 mm screws.
A
B
C
A. Lower horizontal support
B. 8 - 4.2x8 mm screws
C. 4 - Lower vertical supports
49-2000833 Rev. 0