Vl6A Specifications; System Specifications; Putting Into Operation - Harman JBL Professional VL6A Guia Del Usuario

System Specifications

System Type:
Number of lanes:
Amplifier:
Input impedance:
Line input gain:
LED indicators:
Cooling:
AC voltage input:
Power (RMS) by speaker:
Treble:
Middle - Bass:
Power (PICO) by speaker:
Treble:
Middle - Bass:
Speaker Impedance:
Frequency Response (± 10 dB):
Horizontal Coverage(-6dB@16KHz): 100°
Vertical Cover:
Maximum SPL (Calculated):
Bass - Treble:
Connectors:
Safety factor:
10 boxes: 5:1 6 boxes: 7:1
Weight per box (kg):
Basic dimensions (WxHxD) mm:
Recommended EQ:
PEQ 1 Freq. 250 Hz Q= 6,64, gain= -3db
PEQ 1 Freq. 654Hz Q= 3,10, gain= +6db
PEQ 1 Freq. 2519Hz Q= 3,68, gain= -6db
PEQ 1 Freq. 15395Hz Q= 2,92, gain= +5,5db
Never in any case interconnect more
than 04 boxes in parallel.
LINE ARRAY box
2
D-Class
40KΩ
Infinite up to +26.8dB (maximum input level of + 14dBu)
Power, Signal, Limit, Error
Passive (without fans)
100-127VAC 50/60Hz; 230-240VAC 50/60Hz
D225Ti - 25W RMS
(2x) 6W16P –275W RMS (total)
D225Ti - 150W
(2x) 6W16P – 550W (total)
8 Ohms
94Hz – 18KHz
Depends on the number of boxes and configuration
120dB
Audio(Balanced) (XLR/F – Line IN___XLR/M – Line OUT)
AC Power (Powercom Type)
4 boxes: 10:1
14Kg
552x199x256
01)
02)
03)
04)
the AC IN connector;
05)
06)
the rear panel of the amplifier will light up.
07)
potentiometer. A good starting point is to adjust the potentiometer in
12 hours.
Audio signal
AC (127V/220V-50/60Hz)

VL6A SPECIFICATIONS

PUTTING INTO OPERATION

Set the volume potentiometer to minimum;
Connect the XLR cable (Signal cable);
Confirm that the power switch is in the OFF position;
Connect the AC power cord supplied with the product to
Plug the power cord into an outlet;
Turn on the power switch and the BLUE power LED on
With the system on, adjust the volume level using the
20