NSS CHAMP 3329 RB Manual De Operaciones página 9

Changing the Battery Type Setting
The standard setting for the onboard battery charger
is Flooded/AGM. EXCEPTION: If your machine was
ordered from NSS equipped with Crown AGM or Gel
batteries, then the charger was configured for Gel
batteries at the factory.
Configuring the Charger for Gel batteries.
1. Remove the top cover.
2. Pull the jumper off the 2-pin connector (position
1), and then move the jumper to position 2 on
only one pin of the 2-pin connector. See photo
below.
3. Reinstall the top cover.
Position 1
For Wet Cell
(Default)
Top cover
(Jumper on
screws
both pins)
Jumper
Location
Configure the Charger for Flooded/AGM batteries
1. Remove the top cover
2. Pull the jumper from the 2-pin connector, and
install the jumper at position 1 (on both pins of
2-pin connector).
3. Reinstall the top cover.
Position 2
For Gel Cell
(Jumper on 1
Pin of 2-Pin
Connector)