Your New Appliance; Accessories; Possible Combinations; Gas Burners - Bosch NNH615XEU Instrucciones De Uso

Your new appliance

Page 2 shows an overall view of your new appliance as well as
the burner power.

Accessories

The following accessories can be purchased from the
Technical Assistance Service:
--------

Gas burners

There are indications to show which burner each control knob
operates.
It is essential to ensure that all the burner parts and pan
supports are correctly installed for the appliance to work
correctly. Do not swap the burner caps around.

Switching on a burner

Turn the desired burner control knob anticlockwise to the
required position.
If the burner does not switch on, wait at least a minute until
trying again.

Safety system

All the hotplates have a security device (thermocouple).
Simmer Plate
This accessory has been
designed to reduce the level
of heat at the lowest power
setting.
Place the accessory directly
on the pan support with the
cones facing upwards, never
directly over the burner. Cen-
tre the pan over the acces-
sory.
Code
HEZ298105 Simmer Plate
The manufacturer accepts no liability if these accessories are
not used or are used incorrectly.

Possible combinations

Hob
NNH615XEU
NPD615XNL
If the burner is switched off during operation (e.g. due to a
draught), the appliance automatically switches on the hotplate
again.
If relighting is not successful (for example, due to food remains
on the burner), the gas supply to this burner is turned off and a
warning sound is given. Turn the control knob to 0.

Switching off a burner

Turn the corresponding control knob clockwise to the 0 setting.
Automatic off
After six hours of operation, the appliance switches off
automatically. Turn all control knobs to setting 0; the appliance
can now be switched on again.

Power levels

The progressive control knobs can be used to control the
power needed, from minimum to maximum power.
Setting Û Control knob off
High flame — Maximum capacity or aperture and
electricity on
Low flame ˜ Minimum capacity or aperture

Protection against overheating

The hob has a protection against overheating system to protect
the electrical installation. This will turn of all burners in case of
overheating and will emit a warning sound.
Turn all control knobs to setting 0. Wait until the appliance has
cooled down sufficiently and turns off. Now you can reconnect
the appliance normally.
Oven
HEV23B250
HEV43T350E
HEV33B551
HEV10B350
HEV43S351
11