Charging Procedure - Motorola PMLN6385 Guia Del Usuario

CHARGING PROCEDURE

1. Plug the charger end of the power supply cord into the power
receptacle located at the bottom of the charger.
2. Plug the wall receptacle end of the power supply cord into
appropriate AC outlet. A successful power-up sequence in indicated
by a SINGLE FLASH GREEN on the charger indicator.
3. Insert a battery or a radio with battery (radio turned off), into the
charger's pocket by:
a. Aligning the groove on each side of the battery with the
corresponding raised rail on each side of the charger pocket.
b. Pressing the battery toward the rear of the pocket.
c. Sliding the battery into the charger pocket, ensuring complete
contact between the charger and battery contacts.
4. When the battery is properly inserted into the pocket, the charger will
indicate the Battery Level status as shown in Table 3. The charger
indicator will illuminate in STEADY RED to indicate the battery is
charging rapidly. When the battery is fully charged, charger indicator
changes to STEADY GREEN.
5. To remove a radio or battery from the charger, use both hands to
remove a radio or battery from the charger pocket. One hand to hold
and support the charger while the other hand to remove the radio or
battery.
5