Motorola WAVE TLK 150 Guia De Instalacion página 30

MN007262A01-AD
Chapter 5: Accessories Installation
Pin No. Pin Name
4 Ext Alarm
5 GPIO_10
6 GPIO_3
7 Ground
8 GPIO_4
9 Emergency SW
10 Ignition Sense
11 Public Address
12 GPIO_7
13 SWB+
14 GPIO_8
15 GPIO_9
16 Speaker+
17 USB D+
18 USB D-
19 VBUS
20 USB Ground
5.1
Emergency Pushbutton or Footswitch Installation
Mount the emergency pushbutton (Motorola Solutions part number RLN4857_) or the footswitch
(Motorola Solutions part number RLN4836_R) using the hardware that comes with the kit. Press the
terminal into the accessory connector housing. Connect the emergency switch wires to pins 9 and 7.
Route the finished cable from the switch location to the control head location.
1
Pulling this line to ground activates the Ext Mic Audio input.
2
GPIO_3 must be grounded if external visor microphone is connected.
3
See Wiring Diagrams and Power Cable chapters for wiring information.
4
GPIO_9 must be grounded if external speaker is connected.
5
CAUTION: Applying greater than 5 V to the pin can cause damage to the circuit.
30
Pin Function
Reserved for future supported and
approved accessories.
Reserved for future supported and
approved accessories.
5 V Level GPIO, External Micro-
2
phone Detection
Ground
Reserved for future supported and
approved accessories.
Emergency Switch Input
3
Ignition Sense Input
Audio output for external speaker.
Reserved for future supported and
approved accessories.
Reserved for future supported and
approved accessories.
Reserved for future supported and
approved accessories.
5 V Level GPIO, External Speaker
4
Detection
Speaker + (3.2 Ω minimum impe-
dance)
Universal Serial Bus Data +
Universal Serial Bus Data -
USB Power (5 V from USB Cable)
Universal Serial Bus Ground
5
5
5